LPC2388 datasheet(29/57 Pages) PHILIPS

29 / 57 page

LPC2388_0

Preliminary data sheet

Rev. 00.02 — 28 January 2008

29 of 57

NXP Semiconductors

LPC2388

Fast communication chip

The ability to separately control rising and falling edge locations allows the PWM to be

used for more applications. For instance, multi-phase motor control typically requires

three non-overlapping PWM outputs with individual control of all three pulse widths and

positions.

Two match registers can be used to provide a single edge controlled PWM output. One

match register (PWMMR0) controls the PWM cycle rate, by resetting the count upon

match. The other match register controls the PWM edge position. Additional single edge

controlled PWM outputs require only one match register each, since the repetition rate is

the same for all PWM outputs. Multiple single edge controlled PWM outputs will all have a

rising edge at the beginning of each PWM cycle, when an PWMMR0 match occurs.

Three match registers can be used to provide a PWM output with both edges controlled.

Again, the PWMMR0 match register controls the PWM cycle rate. The other match

registers control the two PWM edge positions. Additional double edge controlled PWM

outputs require only two match registers each, since the repetition rate is the same for all

PWM outputs.

With double edge controlled PWM outputs, specific match registers control the rising and

falling edge of the output. This allows both positive going PWM pulses (when the rising

edge occurs prior to the falling edge), and negative going PWM pulses (when the falling

edge occurs prior to the rising edge).

7.22.1 Features

• LPC2388 has one PWM block with Counter or Timer operation (may use the

peripheral clock or one of the capture inputs as the clock source).

• Seven match registers allow up to 6 single edge controlled or 3 double edge

controlled PWM outputs, or a mix of both types. The match registers also allow:

– Continuous operation with optional interrupt generation on match.

– Stop timer on match with optional interrupt generation.

– Reset timer on match with optional interrupt generation.

• Supports single edge controlled and/or double edge controlled PWM outputs. Single

edge controlled PWM outputs all go high at the beginning of each cycle unless the

output is a constant low. Double edge controlled PWM outputs can have either edge

occur at any position within a cycle. This allows for both positive going and negative

going pulses.

• Pulse period and width can be any number of timer counts. This allows complete

flexibility in the trade-off between resolution and repetition rate. All PWM outputs will

occur at the same repetition rate.

• Double edge controlled PWM outputs can be programmed to be either positive going

or negative going pulses.

• Match register updates are synchronized with pulse outputs to prevent generation of

erroneous pulses. Software must ‘release’ new match values before they can become

effective.

• May be used as a standard timer if the PWM mode is not enabled.

• A 32-bit Timer/Counter with a programmable 32-bit Prescaler.

LPC2388 Datasheet(PDF) 29 Page - NXP Semiconductors

LPC2388 Datasheet(HTML) 29 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57

Datasheet Download

Link URL