TPS2000C datasheet(16/50 Pages) TI2

16 / 50 page

IOUT

IOS

Decreasing

Load

Resistance

VIN

0 A

0 V

Slope = -RDS(ON)

IOUT

IOS

Decreasing

Load

Resistance

VIN

0 A

0 V

Slope = -RDS(ON)

IOC

Current Limit

with Peaking

Flat Current

Limit

TPS2000C, TPS2001C, TPS2041C, TPS2051C, TPS2061C

TPS2065C, TPS2065C-2, TPS2068C, TPS2069C, TPS2069C-2

SLVSAU6H – JUNE 2011 – REVISED APRIL 2016

www.ti.com

Product Folder Links: TPS2000C TPS2001C TPS2041C TPS2051C TPS2061C TPS2065C TPS2065C-2 TPS2068C

TPS2069C TPS2069C-2

Submit Documentation Feedback

Feature Description (continued)

Figure 22. Current Limit Profiles

8.3.5 FLT

The FLT open-drain output is asserted (active low) during an overload or overtemperature condition. A 9-ms

deglitch on both the rising and falling edges avoids false reporting at start-up and during transients. A current

limit condition shorter than the deglitch period clears the internal timer upon termination. The deglitch timer does

not integrate multiple short overloads and declare a fault. This is also true for exiting from a faulted state. An

input voltage with excessive ripple and large output capacitance may interfere with operation of FLT around IOS

as the ripple drives the TPS20xxC and TPS20xxC-2 in and out of current limit.

If the TPS20xxC and TPS20xxC-2 are in current limit and the overtemperature circuit goes active, FLT goes true

immediately (see Figure 27); however, the exiting this condition is deglitched (see Figure 29). FLT is tripped just

as the knee of the constant-current limiting is entered. Disabling the TPS20xxC and TPS20xxC-2 clears an active

FLT as soon as the switch turns off (see Figure 26). FLT is high impedance when the TPS20xxC and TPS20xxC-

2 are disabled or in undervoltage lockout (UVLO).

8.3.6 Output Discharge

A 470-

Ω (typical) output discharge dissipates stored charge and leakage current on OUT when the TPS20xxC is

in UVLO or disabled. The pulldown circuit loses bias gradually as VIN decreases, causing a rise in the discharge

resistance as VIN falls towards 0 V. The TPS20xxC-2 does not have this function. The output is be controlled by

an external loadings when the device is in ULVO or disabled.

8.4 Device Functional Modes

There are no other functional modes.

TPS2000C Datasheet(PDF) 16 Page - Texas Instruments

TPS2000C Datasheet(HTML) 16 Page - Texas Instruments

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50

Datasheet Download

Link URL