FS2101 datasheet(36/48 Pages) HP

36 / 48 page

General Information

This chapter provides additional reference information including

the characteristics and signal connections for the PCI Active

Analysis Probe module.

The following operating characteristics are not specifications, but

are typical operating characteristics for the PCI Active Analysis

Probe module.

32/64 bit PCI Local bus accepting the short card length and

universal connector pinout. All PCI local bus ground pins of the

universal board pinout are connected to the ground plane of the

PCI Active Analysis Probe module.

The PCI Active Analysis Probe does not implement JTAG

Boundary SCAN. Pins TDI and TBO (pins 4a and 4b) are

connected together so the scan chain is not broken.

The PCI signals PRSNT1# and PRSNT2# are routed to the PCI

Active Analysis Probe extender card connector.

The PCI Local Bus Specification Revision 2.1.

The PCI Active Analysis Probe contains several active

components that buffer the PCI signals before they are acquired

by the logic analyzer. The Analysis Probe takes no power from

the PCI bus but is powered by the logic analyzer.

1660A/C, 1661A/C, 1662A/C, 16550A, 16554A, 16555A,

16556A, 1670A, 1671A, 1672A

32 bit PCI multiplexed - 4 cable headers

32 bit PCI demultiplexed - 6 cable headers

32 bit address demultiplexed, 64 bit data - 9 headers

64 bit PCI multiplexed - 7 cable headers

64 bit PCI demultiplexed - 11 cable headers

Characteristics

Analysis Probe Interface

Compatibility

JTAG Boundary Scan

The PCI Present Pins

Standards Supported

Power Requirements

Logic Analyzer Required

Number of Probes Used

FS2101 Datasheet(PDF) 36 Page - Agilent(Hewlett-Packard)