FS2101 datasheet(33/48 Pages) HP

33 / 48 page

Timing Analysis

The following procedure describes the major steps required to

perform timing analysis measurements with the PCI Active

Analysis Probe module.

Set the State/Timing switch to TIMING. The State LED

will be doused. See page 10 of this manual for details on

the front panel switches.

After removing the probe tip assemblies, plug the logic

analyzer cables into the Analysis Probe cable headers.

See pages 12 and 13 of this manual for details.

Power down the PCI target. Install the PCI Active

Analysis Probe module into a slot in the non-powered

target PCI Local bus. Then power up the target.

Load the logic analyzer configuration file by loading the

appropriate file from the Analysis Probe interface

diskette. See pages 16 and 17 of this manual for

details.

Since the PCI Active Analysis Probe contains active input

buffers it introduces skew to the PCI Local Bus signals. The

skew is as follows:

•

Any PCI bus signal to the PCI clock -1.0 to +2.3ns maximum

•

Any PCI bus signal to any other PCI bus signal 2.1ns

maximum

Installation Quick

Reference

Timing Mode Skew

FS2101 Datasheet(PDF) 33 Page - Agilent(Hewlett-Packard)