M58LR128KB datasheet(40/110 Pages) NUMONYX

40 / 110 page

Configuration Register

M58LR128KT, M58LR128KB, M58LR256KT, M58LR256KB

40/111

6.7

Valid Clock edge bit (CR6)

The valid Clock edge bit, CR6, configures the active edge of the Clock, K, during

synchronous read operations. When the valid Clock edge bit is Low (set to ’0’) the falling

edge of the Clock is the active edge. When the valid Clock edge bit is High (set to ’1’) the

rising edge of the Clock is the active edge.

6.8

Wrap burst bit (CR3)

The wrap burst bit, CR3, selects between wrap and no wrap. Synchronous burst reads can

be confined inside the 4, 8 or 16 word boundary (wrap) or overcome the boundary (no

wrap).

When the Wrap Burst bit is Low (set to ‘0’) the burst read wraps. When it is High (set to ‘1’)

the burst read does not wrap.

6.9

Burst length bits (CR2-CR0)

The burst length bits sets the number of words to be output during a synchronous burst read

operation as result of a single address latch cycle.

They can be set for 4 words, 8 words, 16 words or continuous burst, where all the words are

read sequentially. In continuous burst mode the burst sequence can cross bank boundaries.

In continuous burst mode, in 4, 8 or 16 words no-wrap, depending on the starting address,

the device asserts the WAIT signal to indicate that a delay is necessary before the data is

output.

If the starting address is shifted by 1, 2 or 3 positions from the four-word boundary, WAIT is

asserted for 1, 2 or 3 clock cycles, respectively. When the burst sequence crosses the first

16-word boundary this indicates that the device needs an internal delay to read the

successive words in the array. WAITis asserted only once during a continuous burst access.

See also Table 13: Burst type definition.

CR14, CR5 and CR4 are reserved for future use.

M58LR128KB Datasheet(PDF) 40 Page - Numonyx B.V