9

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

A comprehensive range of CLARKE safety equipment for use when welding is

available from your local dealer. See page 28.

Consideration should be given to shielding the supply cable of permanently

installed welding equipment, in metallic conduit or equivalent. Shielding

should be electrically continuous throughout its length.

The shielding should be connected to the welding power source so that good

electrical contact is maintained between the conduit and the welding power

source enclosure.

The welding equipment should be routinely maintained according to the

manufacturer’s recommendations. All access and service doors and covers

should be closed and properly fastened when the welding equipment is in

operation. The welding equipment should not be modified in any way except

for those changes and adjustments covered in the manufacturer’s

instructions. In particular, the spark gaps of arc striking and stabilizing devices

should be adjusted and maintained according to the manufacturers

recommendations.

SAFETY SYMBOLS

The following symbols may be displayed on the machine.

Read this instruction

booklet carefully

before use.

Do not expose to rain.

Wear welding mask

Recycle unwanted

materials under WEEE

Directive

Wear protective gloves

General Hazard

Wear a dust mask

Warning;- magnetic

field created