HS1 datasheet(13/48 Pages) CLARKE

Part #	HS1

Description	MIG/MMA/TIG INVERTER WELDER

PDF	48 Pages

Scroll/Zoom	100%

Manufacturer	CLARKE [Clarke International]

Direct Link	https://www.clarkeinternational.com/

Logo

13 / 48 page

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

ELECTRICAL CONNECTION

IMPORTANT: This product requires a 64A power supply which may make it

unsuitable for some users. This is a dual voltage machine for connection to either 230

or 400V.

The welder MUST be connected to a 1 phase 50Hz supply through a suitably rated

isolator switch. Before switching on, make sure that the voltage of your electricity

supply is correct. Connecting it to any other power source may cause damage.

If in any doubt, consult a qualified electrician. DO NOT attempt electrical connections

yourself.

WARNING! READ THESE ELECTRICAL SAFETY INSTRUCTIONS

THOROUGHLY BEFORE CONNECTING THE PRODUCT TO A

POWER SUPPLY. THE INSTALLATION OF THIS APPLIANCE

SHOULD BE CARRIED OUT BY A COMPETENT ELECTRICIAN AND

BE IN ACCORDANCE WITH CURRENT IEE WIRING

REGULATIONS (BS4343).

HS1 Datasheet(PDF) 13 Page - Clarke International