HS1 datasheet(21/48 Pages) CLARKE

21 / 48 page

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

1. Open the side panel and remove the

locking nut.

• The retaining locknut nut has a left-

hand thread.

2. Place a spool of welding wire over the

spindle.

• DO NOT release the tension on the

wire as it will unravel, causing

feeding problems later.

• The wire will feed off the spool anticlockwise from the bottom of the reel.

• The spool must be fitted in the correct orientation otherwise it will not feed

correctly.

3. Replace the retaining nut to secure the spool.

SETTING THE DRIVE ROLLER SIZE

1. Release the tensioning handle and

hinge it towards you.

2. Lift up the arm.

3. Unscrew each knurled knob and

remove it in order to pull off the

guide rollers.

• The groove size is stamped on the

corresponding side of the roller.

4. Select the groove size according to

the size of the wire you are using and put the roller back on the spindle with your

chosen side facing you.

5. Replace the chosen roller onto the spindle. Secure with the knuled knob and re-

tension the locking handle.

THREADING THE WIRE

IMPORTANT: Do not release the tension on the wire spool as it will

unravel causing feeding problems later.

1. Pull out the end of the wire from the spool, taking care not to release the tension.

WARNING: NEVER OPERATE THIS MACHINE WITH THE SIDE

PANELS PARTIALLY OPENED OR REMOVED.

HS1 Datasheet(PDF) 21 Page - Clarke International