15

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

7. Pull off the torch shroud with a

twisting movement, (if a tight fit,

some hand grips will be required)

then unscrew the contact tip.

8. Connect the welder to the power

supply and switch ON.

9. Set the ‘WIRE SPEED’ rotary control

on the front panel to position 4 or 6

and squeeze the trigger on the torch

body.

• The wire will feed through the

hose until it appears at the torch

tip.

• Ensuring the hose is free from

kinks during this process will assist

the wire in its passage through the

hose liner.

10. Release the trigger and switch off the welder and disconnect the machine from

the mains supply.

11. Refit the appropriate size contact tip (0.9 mm, for no gas welding is supplied

fitted) to suit your wire. then replace the shroud.

12. Trim the welding wire so that it protrudes no more than 5 mm from the end of the

contact tip.