HD6432142 datasheet(773/1177 Pages) RENESAS

773 / 1177 page

Section 23 ROM (H8S/2148 F-ZTAT A-Mask Version, H8S/2147 F-ZTAT A-Mask Version, H8S/2144 F-ZTAT A-Mask Version)

Rev. 4.00 Sep 27, 2006 page 729 of 1130

REJ09B0327-0400

23.10.10

Notes on Memory Programming

• When programming addresses which have previously been programmed, carry out auto-

erasing before auto-programming.

• When performing programming using programmer mode on a chip that has been

programmed/erased in an on-board programming mode, auto-erasing is recommended before

carrying out auto-programming.

Notes: 1. The flash memory is initially in the erased state when the device is shipped by Renesas.

For other chips for which the erasure history is unknown, it is recommended that auto-

erasing be executed to check and supplement the initialization (erase) level.

2. Auto-programming should be performed once only on the same address block.

23.11

Flash Memory Programming and Erasing Precautions

Precautions concerning the use of on-board programming mode and programmer mode are

summarized below.

Use the specified voltages and timing for programming and erasing.

Applied voltages in excess of the rating can permanently damage the device. For a PROM

programmer, use Renesas Technology microcomputer device types with 128-kbyte or 64-kbyte

on-chip flash memory that support a 3.3-V programming voltage.

Do not select the HN28F101, or use a programming voltage of 5.0 V for the PROM programmer,

and only use the specified socket adapter. Incorrect use will result in damaging the device.

Powering on and off

When applying or disconnecting V

CC, fix the RES pin low and place the flash memory in the

hardware protection state.

The power-on and power-off timing requirements should also be satisfied in the event of a power

failure and subsequent recovery.

Use the recommended algorithm when programming and erasing flash memory.

The recommended algorithm enables programming and erasing to be carried out without

subjecting the device to voltage stress or sacrificing program data reliability. When setting the P or

E bit in FLMCR1, the watchdog timer should be set beforehand as a precaution against program

runaway, etc.

HD6432142 Datasheet(PDF) 773 Page - Renesas Technology Corp