H83069RF datasheet(161/1003 Pages) RENESAS

161 / 1003 page

Rev. 5.0, 09/04, page 139 of 978

6.3.4

Chip Select Signals

For each of areas 0 to 7, the H8/3069R can output a chip select signal (

0 to CS7) that goes low

when the corresponding area is selected in expanded mode. Figure 6.4 shows the output timing of

CSn signal.

Output of

0 to CS

3: Output of CS0 to CS3 is enabled or disabled in the data direction register

(DDR) of the corresponding port.

In the expanded modes with on-chip ROM disabled, a reset leaves pin

0 in the output state and

pins

1 to CS3 in the input state.

To output chip select signals

1 to CS3, the corresponding

DDR bits must be set to 1. In the expanded modes with on-chip ROM enabled, a reset leaves pins

0 to CS3 in the input state.

To output chip select signals

0 to CS3, the corresponding DDR bits

must be set to 1. For details, see section 8, I/O Ports.

Output of

4 to CS

7: Output of CS4 to CS7 is enabled or disabled in the chip select control

4 to CS7 in the input state.

To output chip select signals

4 to CS7, the corresponding CSCR bits must be set to 1.

For details, see section 8, I/O Ports.

Address

External address in area n

+5n

Figure 6.4

CSn Signal Output Timing (n = 0 to 7)

When the on-chip ROM, on-chip RAM, and on-chip registers are accessed,

0 to CS7 remain

high. The

n signals are decoded from the address signals.

They can be used as chip select

signals for SRAM and other devices.

H83069RF Datasheet(PDF) 161 Page - Renesas Technology Corp