H83069RF datasheet(162/1003 Pages) RENESAS

162 / 1003 page

Rev. 5.0, 09/04, page 140 of 978

6.3.5

Address Output Method

The H8/3069R provides a choice of two address update methods: either the same method as in the

previous H8/300H Series (address update mode 1), or a method in which address update is

restricted to external space accesses or self-refresh cycles (address update mode 2).

Figure 6.5 shows examples of address output in these two update modes.

On-chip

memory cycle

On-chip

memory cycle

External

read cycle

On-chip

memory cycle

External

read cycle

Address update

mode 1

Address update

mode 2

Figure 6.5 Sample Address Output in Each Address Update Mode

(Basic Bus Interface, 3-State Space)

Address Update Mode 1: Address update mode 1 is compatible with the previous H8/300H

Series. Addresses are always updated between bus cycles.

Address Update Mode 2: In address update mode 2, address updating is performed only in

external space accesses or self-refresh cycles. In this mode, the address can be retained between

an external space read cycle and an instruction fetch cycle (on-chip memory) by placing the

program in on-chip memory. Address update mode 2 is therefore useful when connecting a

device that requires address hold time with respect to the rise of the

RD strobe.

Switching between address update modes 1 and 2 is performed by means of the ADRCTL bit in

ADRCR. The initial value of ADRCR is the address update mode 1 setting, providing

compatibility with the previous H8/300H Series.

H83069RF Datasheet(PDF) 162 Page - Renesas Technology Corp