LSN2-T/30-D12 Series

DOSA-SIP, 30A POL DC/DC Converters

www.murata-ps.com

MDC_LSN2-T/30-D12 Series.B15 Page 2 of 17

PART NUMBER STRUCTURE

PERFORMANCE SPECIFICATIONS AND ORDERING GUIDE ➀

Output

Input

Package

(Case/

Pinout)

(Volts)

(Amps)

Power

(Watts)

(Volts)

(Volts)

(mA/A)

Typ.

Max.

Line

Load

Min.

Typ.

LSN2-T/30-D12-C

0.8-5

30

150

25

50

±0.1%

±0.1%

12

6-14

200/11.1

93%

94%

B13, P71

Maximum Rated Output

Current in Amps

Non-Isolated Through-hole

Output Configuration:

L = Unipolar

Low Voltage

Nominal Output Voltage:

0.8-5 Volts

L SN2

- /

D12

-

-

T 30

G

Note:

Some model number combina-

tions may not be available. Contact

Murata Power Solutions.

Input Voltage Range:

D12 = 7-14 Volts (12V nominal)

Power Good:

Blank = Omitted (default)

G = Installed (special quantity orders required)

RoHS-6 hazardous

substance compliant

➀

models are tested and specified with external 22µF tantalum input and output 0.01//0.1//10µF

capacitors. These capacitors are necessary to accommodate our test equipment and may not

be required to achieve specified performance in your applications. See I/O Filtering and

Noise Reduction.

➁

reduced with external filtering. See I/O Filtering and Noise Reduction for details.

➂

These devices have no minimum-load requirements and will regulate under no-load conditions.

Regulation specifications describe the output-voltage deviation as the line voltage or load is

varied from its nominal/midpoint value to either extreme.

➃

Nominal line voltage, no-load/full-load conditions.

➄

➅

➆

Please refer to the Part Number Structure for additional options when ordering.

C

Murata Power Solutions recommends the specifications below when installing these converters. These specifications vary depending on the solder type.

Exceeding these specifications may cause damage to the product. Be cautious when there is high atmospheric humidity. We strongly recommend a mild

pre-bake (100ºC. for 30 minutes). Your production environment may differ therefore please thoroughly review these guidelines with your process engineers.

Wave Solder Operations for through-hole mounted products (THMT)

For Sn/Ag/Cu based solders:

Maximum Preheat Temperature

115ºC.

Maximum Pot Temperature

270ºC.

Maximum Solder Dwell Time

7 seconds

For Sn/Pb based solders:

Maximum Preheat Temperature

105ºC.

Maximum Pot Temperature

250ºC.

Maximum Solder Dwell Time

6 seconds

SOLDERING GUIDELINES