HS-3000 datasheet(42/46 Pages) BOSER

42 / 46 page

4.10 Change Supervisor/User Password

AMIBIOS SETUP – PERIPHERAL SETUP

Standard CMOS Setup

Advanced CMOS Setup

Advanced Chipset Setup

Power Management Setup

Enter new supervisor password: _

Change Supervisor Password

Auto Configuration with Optimal Settings

Auto Configuration with Fail Safe Settings

Save Settings and Exit

Exit Without Saving

Standard CMOS setup for changing time, date, hard disk type, etc.

ESC:Exit

:Sel F2/F3: Color F10: Save & Exit

You can set either supervisor or user password, or both of then. The

differences between are:

supervisor password: can enter and change the options of the setup

menus.

user password: just can only enter but do not have the right to change the

options of the setup menus.

When you select this function, the following message will appear at the

center of the screen to assist you in creating a password.

ENTER PASSWORD:

Type the password, up to eight characters in length, and press

<Enter>. The password typed now will clear any previously entered

password from CMOS memory. You will be asked to confirm the

password. Type the password again and press <Enter>. You may also

press <Esc> to abort the selection and not enter a password.

To disable a password, just press <Enter> when you are prompted to

enter the password. A message will confirm the password will be

disabled. Once the password is disabled, the system will boot and you

can enter Setup freely.

PASSWORD DISABLED.

When a password has been enabled, you will be prompted to enter it

every time you try to enter Setup. This prevents an unauthorized

HS-3000 Datasheet(PDF) 42 Page - BOSER Technology Co., Ltd