MP2932 - 6-PHASE PWM CONTROLLER WITH 8-BIT ADC CODE

MP2932 Rev.1.02

www.MonolithicPower.com

17

4/30/2012

MPS Proprietary Information. Patent Protected. Unauthorized Photocopy and Duplication Prohibited.

© 2012 MPS. All Rights Reserved.

Compensation without Load-Line

Regulation

The non load-line regulated converter is

accurately

modeled

as

a

voltage-mode

regulator with two poles at the L-C resonant

frequency and a zero at the ESR frequency. A

type-III controller, as shown in Figure 13,

provides the necessary compensation.

R

C

C

R

COMP

FB

IDROOP

VDIFF

MP2932

R

C

FB

2

C

C

1

1

Figure 13—Compensation Circuit for

MP2932 without Load-line Regulation

The first step is to choose the desired

Choose a frequency high enough to assure

adequate transient performance but not higher

than 1/3 of the switching frequency. The type-III

compensator has an extra high-frequency pole,

much phase shift below the system bandwidth.

Output Inductor

The output inductors and the output capacitor

bank together to form a low-pass filter

responsible for smoothing the pulsating voltage

at the phase nodes. The output filter also must

provide the transient energy until the regulator

can respond.

In high-speed converters, the output capacitor

bank is usually the most costly (and often the

largest) part of the circuit. The critical load

parameters in choosing the output capacitors

are the maximum size of the load step, ΔI; the

load-current slew rate, di/dt; and the maximum

allowable

output

voltage

deviation

under

characterized according to their capacitance,

ESR, and ESL (equivalent series inductance).

At the beginning of the load transient, the

output capacitors supply all of the transient

current. The output voltage will initially deviate

by an amount approximated by the voltage drop

across the ESL. As the load current increases,

the voltage drop across the ESR increases

linearly until the load current reaches its final

value. The capacitors selected must have

sufficiently low ESL and ESR so that the total

output voltage deviation is less than the

allowable maximum. Neglecting the contribution

of inductor current and regulator response, the

output voltage initially deviates by an amount in

Equation (18):



ESR

dt

di

ESL

ΔV





(18)

The filter capacitor must have sufficiently low

The ESR of the bulk capacitors also creates the

majority of the output voltage ripple. As the bulk

capacitors sink and source the inductor AC

ripple current, a voltage develops across the

bulk-capacitor ESR. Thus, once the output

capacitors

are

selected,

the

maximum

the lower limit on the inductance.







MAX

P

-

P

V

IN

V

s

f

OUT

V

OUT

NV

-

IN

V

ESR

L



(19)

Since the capacitors are supplying a decreasing

portion of the load current while the regulator

recovers from the transient, the capacitor

voltage becomes slightly depleted. The output

inductors must be capable of assuming the

entire load current before the output voltage

upper limit on inductance.

Input Capacitor

The input capacitors are responsible for

sourcing the AC component of the input current

flowing into the upper MOSFETs. Their RMS

current capacity must be sufficient to handle the

AC component of the current drawn by the

upper MOSFETs which is related to duty cycle

and the number of active phases.