MACH211SP-12/15/20 (Com’l)

15

Notes:

1. These parameters are not 100% tested, but are evaluated at initial characterization and at any time the design is modified

where frequency may be affected.

2. See Switching Test Circuit for test conditions.

3. If a signal is powered-down, this parameter must be added to its respective high-speed parameter.

Input Latch Gate to Combinatorial Output

17

20

25

ns

Input Latch Gate to Output Through Transparent

Output Latch

19

22

27

ns

Setup Time from Input, I/O, or Feedback Through

Transparent Input Latch to Output Latch Gate

912

15

ns

Input Latch Gate to Output Latch Setup

13

16

21

ns

Input Latch Gate Width LOW

6

6

8

ns

Input, I/O, or Feedback to Output Through

Transparent Input and Output Latches

16

19

24

ns

Asynchronous Reset to Registered or Latched

Output

16

20

25

ns

Asynchronous Reset Width (Note 1)

12

15

20

ns

Asynchronous Reset Recovery Time (Note 1)

8

10

15

ns

Asynchronous Preset to Registered or Latched

Output

16

20

25

ns

Asynchronous Preset Width (Note 1)

12

15

20

ns

Asynchronous Preset Recovery Time (Note 1)

8

10

15

ns

Input, I/O, or Feedback to Output Enable (Note 1)

15

15

15

ns

Input, I/O, or Feedback to Output Disable

(Note 1)

15

15

15

ns

(Note 3)

10

10

10

ns

10

10

10

ns

(Note 3)

000

ns

(Note 3)

10

10

10

ns

SWITCHING CHARACTERISTICS over COMMERCIAL operating ranges (Note 2)

(continued)

Parameter

Symbol

Parameter Description

-12

-15

-20

Unit

Min

Max

Min

Max

Min

Max