Updating the Firmware

www.ti.com

When opening the box, locate the debug connector header next to the target connector. Connect this

header to another CC Debugger (see Figure 18) or to a SmartRF05EB (see Figure 19). When using

SmartRF05EB, connect a 10-pin flat cable from the “Ext SoC Debug” plug (P3) on the EB to the “USB

Debug” plug (P2) on the CC Debugger. The dead debugger needs power, so connect the USB cable. Turn

on the SmartRF05EB or debugger - it should detect the USB Controller (CC2511) on the debugger.

Figure 18. Programming the Bootloader on the CC Debugger Using Another CC Debugger

Figure 19. Programming the Bootloader on the CC Debugger Using SmartRF05EB

18

CC Debugger

SWRU197H – September 2010 – Revised April 2014

Submit Documentation Feedback

Copyright © 2010–2014, Texas Instruments Incorporated