AT90PWM2 datasheet(161/365 Pages) ATMEL

161 / 365 page

161

4317K–AVR–03/2013

AT90PWM2/3/2B/3B

Thanks to this feature, we can for example configure two PSC in slave mode (PARUNn = 1 /

PRUNn = 0) and one PSC in master mode (PARUNm = 0 / PRUNm = 0). This PSC master can

start all PSC at the same moment (PRUNm = 1).

16.22.1

Fault events in Autorun mode

To complete this master/slave mechanism, fault event (input mode 7) is propagated from PSCn-

1 to PSCn and from PSCn to PSCn-1.

A PSC which propagate a Run signal to the following PSC stops this PSC when the Run signal

is deactivate.

According to the architecture of the PSC synchronization which build a “daisy-chain on the PSC

run signal” beetwen the three PSC, only the fault event (mode 7) which is able to “stop” the PSC

through the PRUN bits is transmited along this daisy-chain.

A PSC which receive its Run signal from the previous PSC transmits its fault signal (if enabled)

to this previous PSC. So a slave PSC propagates its fault events when they are configured and

enabled.

16.23 PSC Clock Sources

PSC must be able to generate high frequency with enhanced resolution.

Each PSC has two clock inputs:

•

CLK PLL from the PLL

•

CLK I/O

Figure 16-39. Clock selection

PCLKSELn bit in PSC n Configuration register (PCNFn) is used to select the clock source.

PPREn1/0 bits in PSC n Control Register (PCTLn) are used to select the divide factor of the

clock.

CLK

CLK PSCn

CLK

PLL

I/O

PRESCALER

PPREn1/0

PCLKSELn

(1) : CK/16 for AT90PWM2/3

(2) : CK/64 for AT90PWM2/3

AT90PWM2 Datasheet(PDF) 161 Page - ATMEL Corporation