AT90PWM2 datasheet(195/365 Pages) ATMEL

195 / 365 page

195

4317K–AVR–03/2013

AT90PWM2/3/2B/3B

Note:

1. The example code assumes that the part specific header file is included.

For I/O Registers located in extended I/O map, “IN”, “OUT”, “SBIS”, “SBIC”, “CBI”, and “SBI”

instructions must be replaced with instructions that allow access to extended I/O. Typically

“LDS” and “STS” combined with “SBRS”, “SBRC”, “SBR”, and “CBR”.

The function simply waits for data to be present in the receive buffer by checking the RXC flag,

before reading the buffer and returning the value.

18.7.2

Receiving Frames with 9 Data Bits

If 9-bit characters are used (UCSZ=7) the ninth bit must be read from the RXB8 bit in UCSRB

before reading the low bits from the UDR. This rule applies to the FE, DOR and UPE Status

Flags as well. Read status from UCSRA, then data from UDR. Reading the UDR I/O location will

change the state of the receive buffer FIFO and consequently the TXB8, FE, DOR and UPE bits,

which all are stored in the FIFO, will change.

The following code example shows a simple USART receive function that handles both nine bit

characters and the status bits.

TABLE 3.

Assembly Code Example

(1)

USART_Receive:

; Wait for data to be received

sbis

UCSRA, RXC

rjmp

USART_Receive

; Get and return received data from buffer

lds

r16, UDR

ret

C Code Example

(1)

unsigned char

USART_Receive( void )

{

/* Wait for data to be received */

while

( !(UCSRA & (1<<RXC)) )

;

/* Get and return received data from buffer */

return

UDR;

}

AT90PWM2 Datasheet(PDF) 195 Page - ATMEL Corporation

AT90PWM2 Datasheet(HTML) 195 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL