| Electronic Components Datasheet Search |
|
ICS1892 Datasheet(PDF) 66 Page - Integrated Circuit Systems |
|
|
|||||||||||||||||||||||||||||
ICS1892 Datasheet(HTML) 66 Page - Integrated Circuit Systems |
|
66 / 148 page ![]() ICS1892, Rev. D, 2/26/01 February 26, 2001 66 Chapter 8 Management Register Set ICS1892 Data Sheet © 2000-2001, Integrated Circuit Systems, Inc. All rights reserved. 8.3 Register 1: Status Register Table 8-6 lists the bits for the Status Register, an interface between the ICS1892 and the STA that has 16 bits of data. There are two types of status bits: some report the capabilities of the ICS1892, and some indicate the state of signals used to monitor internal circuits. The STA accesses the Status Register using the Serial Management Interface. During a reset, the ICS1892 initializes the Status Register bits to pre-defined, default values. Note: For an explanation of acronyms used in Table 8-5, see Chapter 1, “Abbreviations and Acronyms”. † As per the IEEE Std 802.3u, during any write operation to any bit in this register, the STA must write the default value to all Reserved bits. 8.3.1 100Base-T4 (bit 1.15) The STA reads this bit to learn if the ICS1892 can support 100Base-T4 operations. Bit 1.15 of the ICS1892 is permanently set to logic zero, which informs an STA that the ICS1892 cannot support 100Base-T4 operations. Table 8-6. Status Register (Register 1 [0x01]) Bit Definition When Bit = 0 When Bit = 1 Ac- cess SF De- fault Hex 1.15 100Base-T4 Always 0. (Not supported.) N/A RO – 0 7 1.14 100Base-TX full duplex Mode not supported Mode supported CW – 1 1.13 100Base-TX half duplex Mode not supported Mode supported CW – 1 1.12 10Base-T full duplex Mode not supported Mode supported CW – 1 1.11 10Base-T half duplex Mode not supported Mode supported CW – 1 8 1.10 IEEE reserved Always 0 N/A CW – 0† 1.9 IEEE reserved Always 0 N/A CW – 0† 1.8 IEEE reserved Always 0 N/A CW – 0† 1.7 IEEE reserved Always 0 N/A CW – 0† 0 1.6 MF Preamble suppression PHY requires MF Preambles PHY does not require MF Preambles RO – 0 1.5 Auto-Negotiation complete Auto-Negotiation is in process, if enabled Auto-Negotiation is completed RO LH 0 1.4 Remote fault No remote Fault Detected Remote fault detected RO LH 0 1.3 Auto-Negotiation ability N/A Always 1: PHY has Auto-Negotiation ability RO – 1 9 1.2 Link status Link is invalid/down Link is valid/established RO LL 0 1.1 Jabber detect No jabber condition Jabber condition detected RO LH 0 1.0 Extended capability N/A Always 1: PHY has extended capabilities RO – 1 |
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |