UPD62AMC datasheet(16/62 Pages) NEC

16 / 62 page

µPD62A

Data Sheet U14474EJ1V0DS00

3.2 KI Port/Special Ports (P1)

3.2.1 KI port (P11: bits 4 to 7 of P1)

The KI port is a 4-bit input port for key entry.

The pin status can be read at this port.

Software can be used to set whether to connect a pull-down resistor at the KI port in 4-bit units by means of bit

5 of the P4 register.

When reset, a pull-down resistor is connected.

Table 3-3. KI/Special Port Register (P1)

Bit

Name

KI3

KI2

KI1

KI0

S1/LED

(Fixed to 1)

b2:

In input mode, the status of the S0 pin is read (Read only).

In OFF mode, this bit is fixed to 1.

b3:

The status of the S1/LED pin is read regardless of input/output mode (Read only).

b4 to b7:

The status of the KI pin is read (Read only).

Caution In order to prevent malfunction, be sure to input a low level to more than one of pins KI0 to KI3

when reset is released (when the RESET pin changes from low level to high level, or POC is

released due to supply voltage startup).

3.2.2 S0 port (bit 2 of P1)

The S0 port is the input/OFF mode port.

The pin status can be read by setting this port to input mode with bit 0 of the P4 register.

In input mode, software can be used to set whether to connect a pull-down resistor at the S0 and S1/LED ports

in 2-bit units by means of bit 4 of the P4 register.

If input mode is canceled (set to OFF mode), the pin becomes high-impedance, but the through current is stopped

from flowing internally. In OFF mode, “1” can be read regardless of the pin status.

When reset, this port is set to OFF mode and becomes high-impedance.

3.2.3 S1/LED (bit 3 of P1)

The S1/LED port is an input/output port.

This port is set input or output mode by means of bit 2 of the P4 register. The pin status can be read in both

input and output mode.

In input mode, software can be used to set whether to connect a pull-down resistor at the S0 and S1/LED ports

in 2-bit units by means of bit 4 of the P4 register.

In output mode, the pull-down resistor is automatically disconnected, and this port becomes the remote control

transmission display pin (refer to 4. TIMER).

When reset, this port is placed in output mode, and a high level is output.

UPD62AMC Datasheet(PDF) 16 Page - NEC

UPD62AMC Datasheet(HTML) 16 Page - NEC

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62

Datasheet Download

Link URL