23 PA

UVLO

LM5035C

STANDBY

OFF

OFF

STANDBY

1.25V

0.4V

23 PA

R2

R1

¨

¨

©

§

¨

¨

©

§

LM5035C

SNVS631C – JANUARY 2010 – REVISED MARCH 2013

www.ti.com

Table 2. UVO/OVP Divider Formulas

Outputs disabled due to VIN falling below UVLO threshold

(11)

Outputs enabled due to VIN rising above UVLO threshold

Outputs disabled due to VIN rising above OVP threshold

(12)

Outputs enabled due to VIN falling below OVP threshold

The typical operating ranges of undervoltage and overvoltage thresholds are calculated from the above

equations. For example, for resistor values R1 = 86.6k

Ω, R2 = 2.10kΩ and R3 = 1.40kΩ the computed

thresholds are:

•

UVLO turn-off = 32.2V

•

UVLO turn-on = 34.2V

•

OVP turn-on = 78.4V

•

OVP turn-off = 80.5V

Figure 25. Remote Standby and Disable Control

To maintain the threshold’s accuracy, a resistor tolerance of 1% or better is recommended.

The design process starts with the choice of the voltage difference between the UVLO enabling and disabling

thresholds. This will also approximately set the difference between OVP enabling and disabling regulation:

(13)

threshold:

(14)

(15)

(16)

Remote configuration of the controller’s operational modes can be accomplished with open drain device(s)

connected to the UVLO pin as shown in Figure 25.

22

Submit Documentation Feedback

Copyright © 2010–2013, Texas Instruments Incorporated

Product Folder Links: LM5035C