www.ti.com

THS7315

SLOS532 – JUNE 2007

EVALUATION BOARD/KIT IMPORTANT NOTICE (continued)

The user assumes all responsibility and liability for proper and safe handling of the goods. Further, the user

indemnifies TI from all claims arising from the handling or use of the goods. Due to the open construction of the

product, it is the user’s responsibility to take any and all appropriate precautions with regard to electrostatic

discharge.

EXCEPT TO THE EXTENT OF THE INDEMNITY SET FORTH ABOVE, NEITHER PARTY SHALL BE LIABLE

TO THE OTHER FOR ANY INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES.

TI currently deals with a variety of customers for products, and therefore our arrangement with the user is not

exclusive.

TI assumes no liability for applications assistance, customer product design, software performance, or

infringement of patents or services described herein.

Please read the User’s Guide and, specifically, the Warnings and Restrictions notice in the User’s Guide prior

to handling the product. This notice contains important safety information about temperatures and voltages. For

additional information on TI’s environmental and/or safety programs, please contact the TI application engineer

or visit www.ti.com/esh.

No license is granted under any patent right or other intellectual property right of TI covering or relating to any

machine, process, or combination in which such TI products or services might be or are used.

FCC Warning

This evaluation board/kit is intended for use for ENGINEERING DEVELOPMENT, DEMONSTRATION, OR

EVALUATION PURPOSES ONLY and is not considered by TI to be a finished end-product fit for general

consumer use. It generates, uses, and can radiate radio frequency energy and has not been tested for

compliance with the limits of computing devices pursuant to part 15 of FCC rules, which are designed to

provide reasonable protection against radio frequency interference. Operation of this equipment in other

environments may cause interference with radio communications, in which case the user at his own expense

will be required to take whatever measures may be required to correct this interference.

EVM WARNINGS AND RESTRICTIONS

It is important to operate this EVM within the input voltage range of 2.85 V to 5.5 V single supply and the

output voltage range of 0 V to 5.5 V.

Exceeding the specified input range may cause unexpected operation and/or irreversible damage to the EVM.

If there are questions concerning the input range, please contact a TI field representative prior to connecting

the input power.

Applying loads outside of the specified output range may result in unintended operation and/or possible

permanent damage to the EVM. Please consult the EVM User's Guide prior to connecting any load to the EVM

output. If there is uncertainty as to the load specification, please contact a TI field representative.

During normal operation, some circuit components may have case temperatures greater than +85

＝C. The

EVM is designed to operate properly with certain components above +85

＝C as long as the input and output

ranges are maintained. These components include but are not limited to linear regulators, switching transistors,

pass transistors, and current sense resistors. These types of devices can be identified using the EVM

schematic located in the EVM User's Guide. When placing measurement probes near these devices during

operation, please be aware that these devices may be very warm to the touch.

Mailing Address: Texas Instruments, Post Office Box 655303, Dallas, Texas 75265

Copyright © 2007, Texas Instruments Incorporated

21

Submit Documentation Feedback