4752CM01

PAGE 7

DETAILED PRODUCT DESCRIPTION

COPPER SHIELD PLACEMENT

The Q Series is a broad line of ultra-miniature, high reliability DC to HV DC

converters supplying up to 5,000 volts in only 0.125 cubic inches and up to

10,000 volts in only 0.614 cubic inches. These component-sized convert-

ers are ideal for applications requiring minimal size and weight. The output

is directly proportional to the input voltage and is linear from <0.7V input

to maximum input voltage, allowing for an adjustable output voltage. Out-

put is load dependent. A control pin option allows full control of the output

via a high impedance input, ideal for error-amplifier control in closed-loop

systems. Isolation is <+/- 500V bias on output return and output power is

either 0.5 watt or 1.25 watts. No external components or minimum load are

required. The output ripple is extremely low for this package size, as low as

.1%. Light weight and wide temperature range make these units ideal for

portable, battery-powered equipment. Many models feature a dual output

(center tap) option, which creates both a positive and a negative output

from miniature, one low cost unit. An alternate pin pattern is available for

users wishing to upgrade without modifying their board design. Output is

load dependent.

Application notes are available on this series, and technical assistance is

readily available.

Q SERIES

BLOCK DIAGRAM

NOTE: Pin designators for pin out models up to 5KV.

WWW.XPPOWER.COM

Conceptual drawing. Copper shields are factory installed.