409-2426

Pneumatic Tools68068 and 68068-1

Rev A

8 of 17

Tyco Electronics Corporation

Pivot Pins

Retaining

Pin

Cowling

Pin

Jaw Assembly

(Ref)

LowerHousing Cover

Jaw Cam Rollers

Pivot Pin

Holes

Cam

Tool 68068 Shown

Installing Jaw Assembly

Locator(Ref)

Figure 6

4. OPERATING PROCEDURE

Make sure to follow safety precautions (refer to Paragraph 1.4) before and during operation of the tool. Refer to

the instructions included with the jaw assembly for specific wire preparation and crimp inspection requirements.

To avoid personal injury, ALWAYS keep fingers clear of the jaw closure during crimping cycles.

1. Connect the tool to the air supply according to Paragraph 1.2, and check the air pressure according to

Paragraph 1.3.

2. Insert the wire into the wire barrel of the terminal or splice.

3. Place the terminal or splice in the lower jaw (refer to the instructions included with the jaw assembly

for specific location in the jaw).

4. FULLY depress the tool control button (the jaws will close).

5. Release the tool control button to open the jaws, then remove the crimped terminal or splice.

DANGER