8

DLPR910

DLPS065B – SEPTEMBER 2015 – REVISED NOVEMBER 2016

www.ti.com

Product Folder Links: DLPR910

Submit Documentation Feedback

Copyright © 2015–2016, Texas Instruments Incorporated

Feature Description (continued)

7.3.1.3 Output Enable and Reset

When the OE/(RESET) input is held low, the address counter is reset and the Data and CLKOUT outputs are

7.3.1.4 Chip Enable

The (CE) input is asserted by the DLPC910 to enable the Data and CLKOUT outputs. When (CE) is held high,

the DLPR910 address counter is reset, and the Data and CLKOUT outputs are placed in high-impedance states.

7.3.1.5 Configuration Pulse

The DLPR910 is configured in serial mode when the Configuration Pulse (CF) is held high and (CE) and OE are

enabled. New data is available a short time after each rising clock edge.

7.3.1.6 Revision Selection

REV_SEL_0, REV_SEL_1, and (EN_EXT_SEL) signals are used for selecting which revision to be the default.

Setting all three signals to GND will default to revision 0 for simple DLPR910 setup.

7.4 Device Functional Modes

To successfully program the DLPC910 upon power-up, the DLPR910 must be configured and connected to the

DLPC910 as shown in Figure 2.