ARM7 datasheet(18/38 Pages) PHILIPS

18 / 38 page

9397 750 14985

Preliminary data sheet

Rev. 01 — 3 October 2005

18 of 38

Philips Semiconductors

LPC2141/42/44/46/48

Single-chip 16-bit/32-bit microcontrollers

6.13.1 Features

• Compliant with SPI speciﬁcation.

• Synchronous, Serial, Full Duplex, Communication.

• Combined SPI master and slave.

• Maximum data bit rate of one eighth of the input clock rate.

6.14 SSP serial I/O controller

The LPC2141/42/44/46/48 each contain one SSP. The SSP controller is capable of

operation on a SPI, 4-wire SSI, or Microwire bus. It can interact with multiple masters and

slaves on the bus. However, only a single master and a single slave can communicate on

the bus during a given data transfer. The SSP supports full duplex transfers, with data

frames of 4 bits to 16 bits of data ﬂowing from the master to the slave and from the slave

to the master. Often only one of these data ﬂows carries meaningful data.

6.14.1 Features

• Compatible with Motorola’s SPI, TI’s 4-wire SSI and National Semiconductor’s

Microwire buses.

• Synchronous serial communication.

• Master or slave operation.

• 8-frame FIFOs for both transmit and receive.

• Four bits to 16 bits per frame.

6.15 General purpose timers/external event counters

The Timer/Counter is designed to count cycles of the peripheral clock (PCLK) or an

externally supplied clock and optionally generate interrupts or perform other actions at

speciﬁed timer values, based on four match registers. It also includes four capture inputs

to trap the timer value when an input signal transitions, optionally generating an interrupt.

Multiple pins can be selected to perform a single capture or match function, providing an

application with ‘or’ and ‘and’, as well as ‘broadcast’ functions among them.

The LPC2141/42/44/46/48 can count external events on one of the capture inputs if the

minimum external pulse is equal or longer than a period of the PCLK. In this conﬁguration,

unused capture lines can be selected as regular timer capture inputs, or used as external

interrupts.

6.15.1 Features

• A 32-bit timer/counter with a programmable 32-bit prescaler.

• External event counter or timer operation.

• Four 32-bit capture channels per timer/counter that can take a snapshot of the timer

value when an input signal transitions. A capture event may also optionally generate

an interrupt.

• Four 32-bit match registers that allow:

– Continuous operation with optional interrupt generation on match.

– Stop timer on match with optional interrupt generation.

ARM7 Datasheet(PDF) 18 Page - NXP Semiconductors

ARM7 Datasheet(HTML) 18 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38

Datasheet Download

Link URL