ARM7 datasheet(22/38 Pages) PHILIPS

22 / 38 page

9397 750 14985

Preliminary data sheet

Rev. 01 — 3 October 2005

22 of 38

Philips Semiconductors

LPC2141/42/44/46/48

Single-chip 16-bit/32-bit microcontrollers

The Wake-up Timer monitors the crystal oscillator as the means of checking whether it is

safe to begin code execution. When power is applied to the chip, or some event caused

the chip to exit Power-down mode, some time is required for the oscillator to produce a

signal of sufﬁcient amplitude to drive the clock logic. The amount of time depends on

many factors, including the rate of VDD ramp (in the case of power on), the type of crystal

and its electrical characteristics (if a quartz crystal is used), as well as any other external

circuitry (e.g. capacitors), and the characteristics of the oscillator itself under the existing

ambient conditions.

6.19.4 Brownout detector

The LPC2141/42/44/46/48 include 2-stage monitoring of the voltage on the VDD pins. If

this voltage falls below 2.9 V, the BOD asserts an interrupt signal to the VIC. This signal

can be enabled for interrupt; if not, software can monitor the signal by reading dedicated

The second stage of low voltage detection asserts reset to inactivate the

LPC2141/42/44/46/48 when the voltage on the VDD pins falls below 2.6 V. This reset

prevents alteration of the ﬂash as operation of the various elements of the chip would

otherwise become unreliable due to low voltage. The BOD circuit maintains this reset

down below 1 V, at which point the POR circuitry maintains the overall reset.

Both the 2.9 V and 2.6 V thresholds include some hysteresis. In normal operation, this

hysteresis allows the 2.9 V detection to reliably interrupt, or a regularly-executed event

loop to sense the condition.

6.19.5 Code security

This feature of the LPC2141/42/44/46/48 allow an application to control whether it can be

debugged or protected from observation.

If after reset on-chip boot loader detects a valid checksum in ﬂash and reads 0x8765 4321

from address 0x1FC in ﬂash, debugging will be disabled and thus the code in ﬂash will be

protected from observation. Once debugging is disabled, it can be enabled only by

performing a full chip erase using the ISP.

6.19.6 External interrupt inputs

The LPC2141/42/44/46/48 include up to nine edge or level sensitive External Interrupt

Inputs as selectable pin functions. When the pins are combined, external events can be

processed as four independent interrupt signals. The External Interrupt Inputs can

optionally be used to wake-up the processor from Power-down mode.

Additionally capture input pins can also be used as external interrupts without the option

to wake the device up from Power-down mode.

6.19.7 Memory mapping control

The Memory Mapping Control alters the mapping of the interrupt vectors that appear

beginning at address 0x0000 0000. Vectors may be mapped to the bottom of the on-chip

ﬂash memory, or to the on-chip static RAM. This allows code running in different memory

spaces to have control of the interrupts.

ARM7 Datasheet(PDF) 22 Page - NXP Semiconductors

ARM7 Datasheet(HTML) 22 Page - NXP Semiconductors

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38

Datasheet Download

Link URL