Datasheet

www.rohm.com

TSZ02201-0GOG0G200770-1-2

©2015 ROHM Co., Ltd. All rights reserved.

5/37

15.Jul.2016 Rev.002

TSZ22111

• 15 • 001

LM393xxx

LM339xxx

LM2903xxx

LM2901xxx

Description of Electrical Characteristics

The relevant electrical terms used in this datasheet are described below. Items and symbols used are also shown.

Note

that item names, symbols, and their meanings may differ from those of

another manufacturer’s document or general

document.

1. Absolute Maximum Ratings

Absolute maximum rating items indicate the condition which must not be exceeded. Application of voltage in excess of the

absolute maximum rating or use out of absolute maximum rated temperature environment may cause deterioration of

electrical characteristics.

(1) Supply Voltage (VCC/VEE)

Indicates the maximum voltage that can be applied between the VCC pin and VEE pin without deterioration of

characteristics of internal circuit.

(2) Differential Input Voltage (VID)

Indicates the maximum voltage that can be applied between the non-inverting and inverting pins without damaging

the IC.

(3) Input Common-mode Voltage Range (VICM)

Indicates the maximum voltage that can be applied to the non-inverting and inverting pins without deterioration or

destruction of electrical characteristics. Input common-mode voltage range of the maximum ratings does not assure

normal operation of IC. For normal operation, use the IC within the input common-mode voltage range characteristics.

(4) Power Dissipation (PD)

Indicates the power that can be consumed by the IC when mounted on a specific board at the ambient temperature 25°C

(normal temperature). As for package product, PD is determined by the temperature that can be permitted by the IC in

the package (maximum junction temperature) and the thermal resistance of the package.

2. Electrical Characteristics

(1) Input Offset Voltage (VIO)

Indicates the voltage difference between non-inverting pin and inverting pin. It can be translated to the input voltage

difference required for setting the output voltage to 0V.

(2) Input Offset Current (IIO)

Indicates the difference of input bias current between the non-inverting and inverting pins.

(3) Input Bias Current (IB)

Indicates the current that flows into or out of the input pin. It is defined by the average of input bias currents at the

non-inverting and inverting pins.

(4) Input Common-mode Voltage Range (VICM)

Indicates the input voltage range at which IC normally operates.

(5) Large Signal Voltage Gain (AV)

Indicates the amplification rate (gain) of output voltage against the voltage difference between non-inverting pin and

inverting pin. It is normally the amplification rate (gain) with reference to DC voltage.

Av = (Output Voltage) / (Differential Input Voltage)

(6) Supply Current (ICC)

Indicates the current that flows within the IC under specified no-load conditions.

(7) Output Sink Current (ISINK)

The maximum current that the IC can output under specific output conditions

(8) Output Saturation Voltage, Low Level Output Voltage (VOL)

Signifies the voltage range that can be output under specific output conditions.

(9) Output Leakage Current, High Level Output Current (ILEAK)

Indicates the current that flows into the IC under specific input and output conditions.

(10) Response Time (tRE)

Response time indicates the delay time between the input and output signal which is determined by the time

difference from the fifty percent of input signal swing to the fifty percent of output signal swing.