CS3318 datasheet(31/44 Pages) CIRRUS

31 / 44 page

DS693F1

CS3318

7. CS3318 REGISTER DESCRIPTIONS

Notes:

When addressing the CS3318 with the Individual Chip Address, all registers are read/write in I²C Mode

and write-only in SPI Mode, unless otherwise noted.

When addressing the CS3318 with the Group Chip Addresses, all registers are write-only in both I²C

and SPI Mode.

7.1

Ch 1-8 Volume - Addresses 01h - 08h

7.1.1

Volume Control (Bits 7:0)

Default = 11010010

Function:

The individual volume control registers allow the user to gain or attenuate the respective channels in

0.5 dB increments. The volume changes are implemented as dictated by the ZCMode[1:0] and Tim-

eOut[2:0] bits in the Device Config 2 register (see “Device Configuration 2 - Address 0Ch” on

page 34).

The value of the Volume Control register is mapped to the desired 0.5 dB step volume setting by the

following equation:

In the equation above, “Desired Volume Setting in dB” is determined by rounding the desired ¼ dB

resolution volume setting down to ½ dB resolution.

It should be noted that input values outside the CS3318’s analog range of +22 dB to -96 dB are valid,

however, the volume of each channel will be limited to the CS3318’s analog range (see “Volume Lim-

its” on page 20).

432

Vol7

Vol6

Vol5

Vol4

Vol3

Vol2

Vol1

Vol0

Gain or Attenuation (dB)*

11111110

+22

11111101

+21.5

11111100

+21

11010100

11010011

+0.5

11010010

11010001

-0.5

11010000

-1

00010100

-95

00010011

-95.5

00010010

-96

* QuarterX = ‘0’. See “¼ dB Control (Bit 0 - 7)” on page 32.

Table 5. Example Volume Settings

Desired Volume Setting in dB

() 210

CS3318 Datasheet(PDF) 31 Page - Cirrus Logic

CS3318 Datasheet(HTML) 31 Page - Cirrus Logic

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44

Datasheet Download

Link URL