TDA4841 datasheet(27/60 Pages) PHILIPS

27 / 60 page

1999 Oct 25

Philips Semiconductors

Product speciﬁcation

I2C-bus autosync deﬂection controller for

PC monitors

TDA4841PS

8. All vertical and EW adjustments are specified at nominal vertical settings; unless otherwise specified, which means:

a) VSIZE = 100% (register VSIZE = 127, VGAIN = 63 and control bit VOVSCN = 0)

b) VSMOD = 0 (no EHT compensation)

c) VPOS centred (register VPOS = 64)

d) VLIN = 0 (register VLIN = X and control bit VSC = 1)

e) VLINBAL = 0 (register VLINBAL = 8)

f) FHMULT = 0

g) HPARAL = 0 (register HPARAL = 32)

h) HPINBAL = 0 (register HPINBAL = 32)

Vertical oscillator synchronized.

9. The output signal at EWDRV (pin 11) may consist of horizontal pincushion + corner correction + DC shift + trapezium

correction. If the VOVSCN control bit is set, and the VPOS adjustment is set to an extreme value, the tip of the

parabola may be clipped at the upper limit of the EWDRV output voltage range. The waveform of corner correction

will clip if the vertical sawtooth adjustment exceeds 110% of the nominal setting.

10. If fH tracking is enabled, the amplitude of the complete EWDRV output signal (horizontal pincushion + corner

correction + DC shift + trapezium) will be changed proportional to IHREF. The EWDRV low level of 1.2 V remains fixed.

11. First pole of transconductance amplifier is 5 MHz without external capacitor (will become the second pole, if the OTA

operates as an integrator).

12. Open-loop gain is

at f = 0 with no resistive load and CBOP = 10 nF (from BOP (pin 3) to GND).

13. The recommended value for the pull-up resistor at pin 6 (BDRV) is 1 k

Ω.

BOP

BIN

--------------

TDA4841 Datasheet(PDF) 27 Page - NXP Semiconductors