6. If the AT Command Mode is successfully Entered , you will receive "Enter AT Mode"（⑤） from

it.

Fig1: +++ enter the AT CMD Mode

7. Select the "Both NL & CR"(

①) and 115200 baud（②） in the two pull-down menu

8. Type or copy the AT command in the dialog（③） like this and press send button（④）

9. If the BLE is successfully configured , you will receive "OK"（⑤） from it.

Fig1: enter the AT command，remember selectting the Both NL & CR

10. If received "ERROR CMD" instead, try sending it again or you should check whether the

command is correct or not.

11. USE “AT+EXIT” to exit AT Mode