DLS360 datasheet(18/40 Pages) CLARKE

18 / 40 page

Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com

PRESSURE REGULATOR

When purchased, the pressure regulator

may be set to minimum.

Turn the pressure regulator on the pump

fully clockwise to allow water pressure to

increase when the pressure washer is

running.

If you find the pressure is too high, you

can adjust this later by turning the

regulator anti-clockwise.

STARTING YOUR POWER WASHER

ELECTRIC START

Prior to starting, refer to your engine manual for the starting procedures for your

engine type.

1. Make sure the engine has sufficient fuel. See page 17.

2. Check the engine, pump & gearbox oil levels. See page 15-16.

3. Connect the high pressure hose and water inlet hoses. See page 13.

NOTE: The power washer is easier to start if you do not turn the water supply on at

this time, see point 7.

4. Set the fuel valve lever to the ‘ON’

position.

WARNING: FAILURE TO TURN ON THE WATER COULD CAUSE

DAMAGE TO THE PUMP.

DLS360 Datasheet(PDF) 18 Page - Clarke International