UG-855 datasheet(4/29 Pages) AD

4 / 29 page

UG-855

EVAL-AD7124-4SDZ User Guide

Rev. 0 | Page 4 of 29

EVAL-AD7124-4SDZ QUICK START GUIDE

To begin using the evaluation board, do the following:

With the EVAL-SDP-CB1Z board disconnected from the

USB port of the PC, install the AD7124-4 EVAL+ Software

(the software is included on the CD in the evaluation kit,

or it can be downloaded from the Analog Devices website).

The PC must be restarted after the software installation is

complete. (For complete software installation instructions,

see the Software Installation Procedures section.)

Connect the EVAL-SDP-CB1Z board to the EVAL-

AD7124-4SDZ board.

Screw the two boards together using the plastic screw and

washer set included in the evaluation board kit to ensure

that the boards are connected firmly together.

Apply an external voltage in the range of 7 V to 9 V to the

J3 or J5 connecter of the EVAL-AD7124-4SDZ board. This

provides the power supply for the board.

Connect the EVAL-SDP-CB1Z board to the PC using the

supplied USB cable. If you are using Windows® XP, you

may need to search for the EVAL-SDP-CB1Z drivers.

Choose to automatically search for the drivers for the

EVAL-SDP-CB1Z board if prompted by the operating

system.

From the Programs menu, go to the Analog Devices

subfolder, and click AD7124 Eval+ to launch the AD7124-4

EVAL+ Software (see the Launching the Software section

for further details).

Figure 2. Hardware Configuration, Setting Up the EVAL-AD7124-4SDZ Evaluation Board

UG-855 Datasheet(PDF) 4 Page - Analog Devices