UG-855 datasheet(11/29 Pages) AD

11 / 29 page

EVAL-AD7124-4SDZ User Guide

UG-855

Rev. 0 | Page 11 of 29

Click Install to confirm that you want to install the drivers.

Figure 12. EVAL-SDP-CB1Z Drivers Setup:

Granting Permission to Install Drivers

To complete the drivers installation, click Finish, which

closes the setup wizard.

Figure 13. EVAL-SDP-CB1Z Drivers Setup:

Completing the Drivers Setup Wizard

Before using the evaluation board, you must restart the PC.

Figure 14. EVAL-SDP-CB1Z Drivers Setup:

Restarting the PC

Setting Up the System for Data Capture

After completing the steps in the Software Installation

Procedures and Evaluation Board Hardware sections, set up the

system for data capture as follows:

Allow the Found New Hardware Wizard to run after the

EVAL-SDP-CB1Z board is plugged into your PC. (If you

are using Windows XP, you may need to search for the

EVAL-SDP-CB1Z drivers. Choose to automatically search

for the drivers for the EVAL-SDP-CB1Z board if prompted

by the operating system.)

Check that the board is connecting to the PC correctly

using the Device Manager of the PC.

Access the Device Manager as follows:

Right-click My Computer and then click Manage.

A dialog box appears asking for permission to allow

the program to make changes to your PC. Click Yes.

The Computer Management window appears. From

the list of System Tools, click Device Manager (see

Figure 15).

The EVAL-SDP-CB1Z board should appear under

ADI Development Tools

, which indicates that the

driver software is installed and that the board is

connecting to the PC correctly.

Figure 15. Device Manager:

Checking that the Board Is Connected to the PC Correctly

UG-855 Datasheet(PDF) 11 Page - Analog Devices