
©2008 Amp’ed RF Inc
1722 Ringwood Ave, Suite 250, San Jose, CA 95131, USA
BT-21 Datasheet
9/29/08
www.ampedrf.com
Page 2 of 12
2
Amp’ed RF, Inc.
(phone) 408 213-9530
(fax) 408 213-9533
Software Architecture
Lower Layer Stack
Full Bluetooth v2.0 data rate (3M bps maximum)
Device power modes—active, sleep and deep sleep
Wake on Bluetooth feature—optimized power consumption of host CPU
Authentication and encryption
Encryption key length from 8-bits to 128-bits maximum
Persistent FLASH memory—for BD Address and radio parameter
storage
All ACL (Asynchronous Connection Less) packet types (DM1, DH1, DM3,
DH3, DM5, DH5, 2-DH1, 2-DH3, 2-DH5, 3-DH1 3-DH3, 3-DH5, AUX1)
SCO (Synchronous Connection Oriented) packet types (HV1, HV2, HV3)
Point to multipoint and scatternet support—3 master and 7 slave links
allowed (10 active links simultaneously)
Park, sniff, and hold modes—fully supported to maximum allowed
intervals
Master slave switch—supported during connection and post connection
Dedicated Inquiry Access Code—for improved inquiry scan performance
Dynamic packet selection—channel quality driven data rate to optimize
link performance
Dynamic power control—interference reduction and link performance
Bluetooth test modes—per Bluetooth v2.0 specification
802.11b co-existence—AWMA and AFH
Vendor specific HCI commands—to support device configuration and
certification test modes
Upper Layer Stack
SPP, OBEX, SDAP, GAP, and DUN protocols
RFComm, SDP, and L2CAP supported
HCI Interface
Bluetooth v2.0 specification compliant
HCI UART transport layer (H4)
Firmware upgrade over UART
APPLICATIONS
ARM7
CPU
EVENTS
COMMANDS
FLASH
MEMORY
UPPER LAYER STACK
HCI
HCI STACK
LM
BASEBAND
RF