4513 datasheet(133/210 Pages) RENESAS

133 / 210 page

APPLICATION

2.3 Timers

2-30

4513/4514 Group User’s Manual

2.3.3 Timer application examples

(1)

Timer operation: measurement of constant period

The constant period by the setting timer count value can be measured.

Outline: The constant period by the timer 1 underflow signal can be measured.

Specifications: Timer 1 and prescaler divides the system clock frequency f(XIN) = 4.0 MHz, and the

timer 1 interrupt request occurs every 3 ms.

Figure 2.3.3 shows the setting example of the constant period measurement.

(2)

CNTR0 output operation: piezoelectric buzzer output

Outline: Square wave output from timer 1 can be used for piezoelectric buzzer output.

Specifications: 4 kHz square wave is output from the CNTR0 pin at system clock frequency f(XIN)

= 4.0 MHz. Also, timer 1 interrupt occurs simultaneously.

Figure 2.3.1 shows the peripheral circuit example, and Figure 2.3.4 shows the setting example of

CNTR0 output.

Fig. 2.3.1 Peripheral circuit example

(3)

CNTR0 input operation: event count

Outline: Count operation can be performed by using the signal (rising waveform) input from CNTR0

pin as the event.

Specifications: The low-frequency pulse from external as the timer 2 count source is input to CNTR0

pin, and the timer 2 interrupt request occurs every 100 counts.

Figure 2.3.5 shows the setting example of CNTR0 input.

4513/4514

CNTR0

125

µs125 µs

Set dividing ratio for timer 1 underflow cycle to 125

µs.

In order to reduce the current dissipation,

output is high-impedance state during buzzer

output stop.

4513 Datasheet(PDF) 133 Page - Renesas Technology Corp