ATmega88 datasheet(25/340 Pages) ATMEL

25 / 340 page

7530H–AVR–02/09

ATmega48/88/168 Automotive

6.1.4

Asynchronous Timer Clock – clk

ASY

The Asynchronous Timer clock allows the Asynchronous Timer/Counter to be clocked directly

from an external clock or an external 32 kHz clock crystal. The dedicated clock domain allows

using this Timer/Counter as a real-time counter even when the device is in sleep mode.

6.1.5

ADC Clock – clk

ADC

The ADC is provided with a dedicated clock domain. This allows halting the CPU and I/O clocks

in order to reduce noise generated by digital circuitry. This gives more accurate ADC conversion

results.

6.2

Clock Sources

The device has the following clock source options, selectable by Flash Fuse bits as shown

below. The clock from the selected source is input to the AVR clock generator, and routed to the

appropriate modules.

Note:

1. For all fuses “1” means unprogrammed while “0” means programmed.

6.2.1

Default Clock Source

The device is shipped with internal RC oscillator at 8.0MHz and with the fuse CKDIV8 pro-

grammed, resulting in 1.0MHz system clock. The startup time is set to maximum and time-out

period enabled. (CKSEL = "0010", SUT = "10", CKDIV8 = "0"). The default setting ensures that

all users can make their desired clock source setting using any available programming interface.

6.2.2

Clock Startup Sequence

Any clock source needs a sufficient V

CC to start oscillating and a minimum number of oscillating

cycles before it can be considered stable.

To ensure sufficient V

CC, the device issues an internal reset with a time-out delay (tTOUT) after

the device reset is released by all other reset sources. “System Control and Reset” on page 41

describes the start conditions for the internal reset. The delay (t

TOUT) is timed from the Watchdog

Oscillator and the number of cycles in the delay is set by the SUTx and CKSELx fuse bits. Th e

selectable delays are shown in Table 6-2. The frequency of the Watchdog Oscillator is voltage

dependent as shown in “Register Summary” on page 318.

Table 6-1.

Device Clocking Options Select(1)

Device Clocking Option

CKSEL3..0

Low Power Crystal Oscillator

1111 - 1000

Full Swing Crystal Oscillator

0111 - 0110

Low Frequency Crystal Oscillator

0101 - 0100

Internal 128 kHz RC Oscillator

0011

Calibrated Internal RC Oscillator

0010

External Clock

0000

Reserved

0001

ATmega88 Datasheet(PDF) 25 Page - ATMEL Corporation

ATmega88 Datasheet(HTML) 25 Page - ATMEL Corporation

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

Datasheet Download

Link URL