LTP5900 Mote Datasheet

Dust Networks

17

Figure 12 LTP5900 Mote Footprint

9.2

Soldering Information

The LTP5900 can be hand soldered with a soldering iron at 230 °C. The soldering iron should be in contact with the pin for

10 seconds or less.

10.0

Regulatory and Standards Compliance

10.1

FCC Compliance

10.1.1

FCC Testing

The LTP5900 mote complies with Part 15.247 modular (Intentional Radiator) of the FCC rules and regulations. In order to

fulfill FCC certification requirements, products incorporating the LTP5900 mote must comply with the following:

1. An external label must be provided on the outside of the final product enclosure specifying the FCC identifier as

described in 10.1.3 below.

2. The antenna must be electrically identical to the FCC-approved antenna specifications for the LTP5900 as described in

10.1.2, with the exception that the gain may be lower than specified in Table 17.

3. The device integrating the LTP5900 mote may not cause harmful interference and must accept any interference received,

including interference that may cause undesired operation.

4. An unintentional radiator scan must be performed on the device integrating the LTP5900 mote, per FCC rules and

regulations, CFR Title 47, Part 15, Subpart B. See FCC rules for specifics on requirements for declaration of conformity.