Hebei I.T. (Shanghai) Co., Ltd.

.

Part No./型号:PLCC6W6

www.ledz.com

11/12

LED SPECIFICATION

10.4.3 Hand Soldering（Not Recommended）/手工焊接（不推荐）

Soldering iron/烙铁焊接：300 degrees C max/不超过300℃；5 seconds max/不超过5s；

once/允许1次.

10.5 Cleaning/清洗

It is recommended that isopropyl alcohol be used as a solvent for cleaning the LEDs. It

should be confirmed beforehand whether the solvents will dissolve the package the resin or not

when using other solvents. Please do not clean the LEDs by the ultrasonic. If it is absolutely

necessary, the influence of ultrasonic cleaning on the LEDs depends on ultrasonic power and the

assembled condition. Before cleaning, a pre-test should be done to confirm whether any damage

to the LEDs will occur.

建议使用酒精作为溶剂清洗LEDs。若要使用其他溶剂，应该预先证实是否能溶化封装

料。请不要使用超声波清洗LEDS，如果一定要使用超声波清洗，则一定要注意超声波的

功率和超声条件。在清洗作业前，必须预先实验确认对LEDS无任何的伤害。

10.6 Static Electricity/静电

It is recommended that a wrist band or an anti-electrostatic glove be used when handling the

LEDs. All devices, equipment and machinery must be properly grounded. It is recommended that

precautions be taken against surge voltage to the equipment that mounts the LEDs.

在接触LEDs时，建议使用防静电手腕带或防静电手套。所有的器件、设备和机器必须

有可靠的接地。对所有LEDs接触的设备，建议采取预防措施消除冲击电压。

PDF created with pdfFactory Pro trial version www.pdffactory.com