DEFENSE SUPPLY CENTER, COLUMBUS

COLUMBUS, OHIO

SIZE

A

CODE IDENT NO.

037Z3

DWG NO.

06019

REV

PAGE

3

1.2.5 Termination finish. Termination finish is identified by a single letter as shown in table III.

TABLE III. Termination finish.

Symbol

Termination finish

M

Palladium-silver

N

Silver-nickel-gold

U

Base metallization-barrier metal-solder coated (tin/lead alloy, with a minimum of 4 percent lead). Solder

has a melting point of +200

°C or less. Solder coat thickness is a minimum of 60 microinches.

Z

Base metallization-barrier metal-tinned (tin/lead alloy, with a minimum of 4 percent lead)

2. APPLICABLE DOCUMENTS

2.1 General. The documents listed in this section are specified in sections 3 and 4 of this specification. This section does not

include documents cited in other sections of this specification or recommended for additional information or as examples. While every

effort has been made to ensure the completeness of this list, document users are cautioned that they must meet all specified

requirements of documents in sections 3 and 4 of this specification, whether or not they are listed.

2.2 Government documents.

2.2.1 Specifications, standards, and handbooks. The following specifications, standards, and handbooks form a part of this

document to the extent specified herein. Unless otherwise specified, the issues of these documents are those cited in the solicitation

or contract (see 6.2).

DEPARTMENT OF DEFENSE SPECIFICATIONS

MIL-PRF-123

-

Capacitors, Fixed, Ceramic Dielectric, (Temperature Stable and General Purpose), High Reliability,

General Specification For

MIL-PRF-55681

-

Capacitor, Chip, Multiple Layer, Fixed, Unencapsulated, Ceramic Dielectric, Established Reliability and

Non-Established Reliability, General Specification For.

MIL-PRF-55681/4

-

Capacitor, Chip, Multiple Layer, Fixed, Ceramic Dielectric, Established Reliability and Non-Established

Reliability, Styles CDR11, CDR12, CDR13, and CDR14 (High Frequency)

DEPARTMENT OF DEFENSE STANDARDS

MIL-STD-202

-

Test Methods for Electronic and Electrical Component Parts.

(Copies of these documents are available online at

http://assist.daps.dla.mil/quicksearch/ or from the Standardization Document

Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094.)

2.3 Order of precedence. In the event of a conflict between the text of this document and the references cited herein, the text of this

document takes precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a specific

exemption has been obtained.