Copyright © Parallax Inc.

Eddie Robot Platform (#28990 & #28992)

v1.2 11/10/2011 Page 8 of 16

Step 6: Control Standoff Assembly

Insert (8) 4-40 x 5/8” black oxide screws from the underside of the Base, and fasten to the two sets of

(4) of standoffs, as shown in Figure 6a. The ½” long standoffs are for the Eddie Control Board, and the

1.5” standoffs are for the Wiring Harness / Switch Plate assembly.

Figure 6a

Place (but do not attach) the Wiring Harness / Switch Plate assembly onto the Base as shown in Figure

6b. Carefully thread the Red and Black wires through the hole that’s between the set of short standoffs.

Double-check to make certain that the Power Switches are both “off” as shown in Figure 6b.

Figure 6b