XC164CS datasheet(63/71 Pages) INFINEON

63 / 71 page

XC164

Derivatives

Timing Parameters

Data Sheet

V2.1, 2003-06

5.2

External Clock Drive XTAL1

Figure 17

External Clock Drive XTAL1

Note: If the on-chip oscillator is used together with a crystal or a ceramic resonator, the

oscillator frequency is limited to a range of 4 MHz to 16 MHz.

It is strongly recommended to measure the oscillation allowance (negative

resistance) in the final target system (layout) to determine the optimum

parameters for the oscillator operation. Please refer to the limits specified by the

crystal supplier.

When driven by an external clock signal it will accept the specified frequency

range. Operation at lower input frequencies is possible but is guaranteed by

design only (not 100% tested).

Table 16

External Clock Drive Characteristics

(Operating Conditions apply)

Parameter

Symbol

Limit Values

Unit

min.

max.

Oscillator period

tOSC SR 20

2501)

The maximum limit is only relevant for PLL operation to ensure the minimum input frequency for the PLL.

High time2)

The clock input signal must reach the defined levels

VILC and VIHC.

–

Low time2)

–

Rise time2)

–

Fall time2)

–

MCT05138

VIHC

VILC

DDI

0.5

OSC

XC164CS Datasheet(PDF) 63 Page - Infineon Technologies AG

XC164CS Datasheet(HTML) 63 Page - Infineon Technologies AG

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71

Datasheet Download

Link URL