Pin 11. E-W OUT: The output waveform at this pin consists

of the sum of the linear sawtooth, 2nd order parabolic and

4th order parabolic waveform components. The center posi-

tion of the output waveform tracks the output voltage at pin

13 (DC OUT). See

Figure 12 for the output schematic.

Pin 12. C

this pin to ground via a short path.

Pin 13. DC OUT: This pin outputs a variable DC voltage from

3.65V to 4.05V. The output voltage is controlled by the con-

trol voltage at pin 1 (POSITION). See

Figure 12 for the out-

put schematic.

Pin 14. V

be decoupled to pin 6 (GND) via a short path with a capacitor

of at least 100 µF.

Pin 15. SAWTOOTH OUT: This pin outputs an S-corrected

sawtooth waveform with the amplitude controlled by pin 2

(HEIGHT). See

Figure 12 for the output schematic.

Pin 16: S: A 0V to 4V DC voltage applied to this pin adjusts

the amount of S correction in the sawtooth waveform at pin

15 (SAWTOOTH OUT). 0V sets maximum S correction. See

Figure 13 for the input schematic.

Input/Output Schematics

DS012894-14

FIGURE 8.

DS012894-15

FIGURE 9.

DS012894-16

FIGURE 10.

DS012894-17

FIGURE 11.

DS012894-18

FIGURE 12.

DS012894-19

FIGURE 13.

7

www.national.com