16

ICS950810

0472F—01/12/04

When PWRDWN# is sampled low by two consecutive rising edges of CPU clock, then all clock outputs except CPU clocks

must be held low on their next high to low transitions. When the I2C Bit 6 of Byte 0 is programmed to '0' CPU clocks must

be held with the CPU clock pin driven high with a value of 2 x Iref, and CPU# undriven. If Bit 6 of Byte 0 is '1' then both

CPU and CPU# are undriven. Note the example below shows CPU = 133 MHz and Bit 6 of Byte 0 = '0', this diagram and

description is applicable for all valid CPU frequencies 66, 100, 133, 200 MHz.

Due to the state if the internal logic, stopping and holding the REF clock outputs in the LOW state may require more than

one clock cycle to complete.

PD# - Assertion (transition from logic "1" to logic "0")

Power Down Assertion of Waveforms

0ns

PD #

CPUT 100MHz

CPUC 100MHz

3V66MHz

PCI 33MHz

USB 48MHz

REF 14.318MHz

25ns

50ns

Power Down De-Assertion Mode

The power-up latency needs to be less than 1.8mS. this is the time from the de-asseration of the powerdown of the ramping

of the power supply until the time that stable clocks are output from the clock chip. If the I

to "1" then the stopped CPU outputs will be driven high within 3 nS of PD# de-asseration.