MB3U, MB3U-I2C

BiSS, SSI, PC-USB ADAPTER

Rev C3, Page 11/16

Configuration

To set the BiSS Master for the sensor(s) connected to it, select Config Slaves and manually configure the BiSS

parameters (data lengths, CRC polynomials, etc.) according to the sensor’s data sheet.

Auto Detection of the Connected Device Configuration

BiSS permits different possibilities and detail levels for an automatic detection of the connected device configura-

tion.

Implemented Auto Detection functions:

• Custom Auto Detection with selected XML file path

• Auto Detection via BiSS EDS

• Auto Detection via BiSS ID and standard BiSS XML file path

• Auto Detection via BiSS Profile ID

Figure 5: Automatic Detection

BiSS XML Files

The file "idbiss6943.xml" is a BiSS device description file for BiSS slave iCs of iC-Haus. Further XML files are

integrated with the date of the software release. For possible updates and new XML files please contact the

manufacturer of your sensor for an appropriate device description file or set the transmission parameters yourself

later. See also at the BiSS website in the identifier section for published XML files http://www.biss-interface.com .

BiSS Reader Configuration Files

Transmission parameter settings can be stored to a *.cfg file for later use with the BiSS software.

Those configuration files can be imported by API(DLL) functions.

Master Configuration Files

The "Save BiSS-Master-Config" writes an BiSS Master Chip configuration description into a *.txt file (e. g. setup

of iC-MB3, MB100). Those BiSS master configuration files can be integrated into configuration code sets for

programming BiSS master iC´s or iP´s to a dedicated BiSS setup.