| Electronic Components Datasheet Search |
|
LTC4012 Datasheet(PDF) 4 Page - Analog Devices |
|
|
|||||||||||||||||||||||||||||
LTC4012 Datasheet(HTML) 4 Page - Analog Devices |
|
4 / 18 page ![]() LTC2959 4 Rev. 0 For more information www.analog.com Note 1: Stresses beyond those listed under Absolute Maximum Ratings may cause permanent damage to the device. Exposure to any Absolute Maximum Rating condition for extended periods may affect device reliability and lifetime. Note 2: All currents into pins are positive, all voltages are referenced to GND unless otherwise specified. Note 3: Average current flowing into the VDD pin. The coulomb counter supply current is a function of the voltage between its inputs. The ADC supply current depends on the channel that is being measured. During ADC conversions that measure the voltage on VSENSEN (ADC voltage mode and register B[2] to ‘1’), current flows into SENSEN. Typically, during such conversions, ISENSEN = VSENSEN/400kΩ. Note 4: The coulomb counter measures static signals as well as dynamic inputs (current pulses). It may take several short pulses to increment/ decrement the ACR. Note 5: The equivalent charge of an LSB in the accumulated charge register depends on the value of RSENSE: QLSB = 533nAh • (50mΩ/RSENSE). Note 7: CB = Capacitance of one bus line in pF (10pF ≤ CB ≤ 400pF). Note 8: Guaranteed by design, not subject to test. ELECTRICAL CHARACTERISTICS SYMBOL PARAMETER CONDITIONS MIN TYP MAX UNITS I2C Timing Characteristics fSCL(MAX) Maximum SCL Clock Frequency l 400 900 kHz tBUF(MIN) Bus Free Time Between STOP/START l 1.3 µs tSU,STA(MIN) Minimum Repeated START Set-Up Time l 600 ns tHD,STA(MIN) Minimum Hold Time (Repeated) START Condition l 600 ns tSU,STO(MIN) Minimum Set-Up Time for STOP Condition 600 ns ttSU,DAT(MIN) Minimum Data Set-Up Time Input l 100 ns tHD,DATI(MIN) Minimum Data Hold Time Input l 50 ns tHD,DATO Data Hold Time Output l 0.3 0.9 µs tOF Data Output Fall Time (Notes 7,8) l 20 + 0.1 • CB 300 ns Timeout Max Time between Last SCL Clock Edge and SDA Release 51.2 ms The l denotes the specifications which apply over the full operating temperature range, otherwise specifications are at TA = 25°C (Note 2). |
|
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |