| Electronic Components Datasheet Search |
|
USB97C210 Datasheet(PDF) 17 Page - SMSC Corporation |
|
|
|||||||||||||||||||||||||||||
USB97C210 Datasheet(HTML) 17 Page - SMSC Corporation |
|
17 / 24 page ![]() USB 2.0 Flash Media Controller Datasheet SMSC USB97C210 Page 17 Revision 1.5 (11-05-03) DATASHEET NAME SYMBOL BUFFER TYPE DESCRIPTION General Purpose I/O GPIO0 /RXD I/O8 This pin may be used either as input, edge sensitive interrupt input, or output. In addition to the above, this port has the capability of auto-toggling at a 1 Hz rate when used as an output. As an input, the GPIO0 can also be used as input to the RXD of a UART in the device for firmware debug purposes. Note: This pin defaults as an input and should be terminated to a supply via a high value resistor to avoid a floating input condition. General Purpose I/O GPIO1 /TXD I/O8 This pin may be used either as input, edge sensitive interrupt input, or output. In addition, as an output, the GPIO1 can also be used as an output TXD of a UART in the device for firmware debug purposes. Note: This pin defaults as an input and should be terminated to a supply via a high value resistor to avoid a floating input condition. General Purpose I/O GPIO2 /T0 I/O8 This pin may be used either as input, edge sensitive interrupt input, or output. In addition, the pin can be used as the internal 8051 “T0 timer P3.4” output. Note: This pin defaults as an input and should be terminated to a supply via a high value resistor to avoid a floating input condition. General Purpose I/O GPIO3 /nWE I/O8 This pin may be used either as input, edge sensitive interrupt input, or output. In addition, the output can be nWE, for use with PCMCIA form factor flash cards with “true IDE” capability. Note: This pin defaults as an input and should be terminated to a supply via a high value resistor to avoid a floating input condition. General Purpose I/O GPIO[7:4] I/O8 This pin may be used either as input, edge sensitive interrupt output, or output. General Purpose I/O GPIO[15:8] I/O8 These pins may be used either as input, or output. RESET input nRESET IS This active low signal is used by the system to reset the chip. The active low pulse must be at least 100ns wide. TEST Input nTEST[0:1] I These signals are used for testing the chip. User should normally leave them unconnected. |
|
|
Link URL |
| Does ALLDATASHEET help your business so far? [ DONATE ] |
About Alldatasheet | Advertisement | Contact us | Privacy Policy | Link to Datasheet | Link Exchange | Manufacturer List All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |