F2M03C2001 datasheet(28/46 Pages) ETC2

28 / 46 page

Rev: 13 September 2005

Class 2 Bluetooth module - F2M03C2

Datasheet

6.2.9 USB 1.1 Compliance

The Bluetooth chip on the F2M03 is qualified to the USB specification v1.1, details of which are available

from http://www.usb.org. The specification contains valuable information on aspects such as PCB track

impedance, supply inrush current and product labelling.

Although F2M03’s Bluetooth chip meets the USB specification, Free2move cannot guarantee that an

application circuit designed around the chip is USB compliant. The choice of application circuit, component

choice and PCB layout all affect USB signal quality and electrical characteristics. The information in this

document is intended as a guide and should be read in association with the USB specification, with

particular attention being given to Chapter 7. Independent USB qualification must be sought before an

application is deemed USB compliant and can bear the USB logo. Such qualification can be obtained from

a USB plugfest or from an independent USB test house.

Terminals USB_DP and USB_DN adhere to the USB specification 1.1 (Chapter 7) electrical requirements.

For ac and dc specifications for terminals USB_DETACH, USB_WAKE_UP, USB_PULL_UP and USB_ON,

refer to section PIO specification.

6.2.10 2.0 Compatibility

F2M03 is compatable with USB specification 2.0 masters; under these circumstances the two ends agree

the mutually acceptable rate of 12Mbits/s according to the USB 2.0 specification.

Page 28(46)

F2M03C2001 Datasheet(PDF) 28 Page - List of Unclassifed Manufacturers