PM7366-PI datasheet(264/286 Pages) PMC

264 / 286 page

RELEASED

PM7366 FREEDM-8

DATA SHEET

PMC-1970930

ISSUE 4

FRAME ENGINE AND DATA LINK MANAGER

PROPRIETARY AND CONFIDENTIAL TO PMC-SIERRA,INC., AND FOR ITS CUSTOMERS’ INTERNAL USE

251

stands for a turn around cycle. A turn around cycle is required on all signals which can be driven

by more than one agent.

During Clock 1, the initiator drives FRAMEB to indicate the start of a cycle. It also drives the

address onto the AD[31:0] bus and drives the C/BEB[3:0] lines with the read command. In the

example below, the command would indicate a burst read. The IRDYB, TRDYB and DEVSELB

signals are in turnaround mode (i.e. no agent is driving the signals for this clock cycle). This cycle

on the PCI bus is called the address phase.

During Clock 2, the initiator ceases to drive the AD[31:0] bus in order that the target can drive it in

the next cycle. The initiator also drives the C/BEB[3:0] lines with the byte enables for the read

data. IRDYB is driven active by the initiator to indicate it is ready to accept the data transfer. All

subsequent cycles on the PCI bus are called data phases.

During Clock 3, the target claims the transaction by driving DEVSELB active. It also places the

first data word onto the AD[31:0] bus and drives TRDYB to indicate to the initiator that the data is

valid.

During Clock 4, the initiator latches in the first data word. The target negates TRDYB to indicate

to the initiator that it is not ready to transfer another data word.

During Clock 5, the target places the second data word onto the AD[31:0] bus and drives TRDYB

to indicate to the initiator that the data is valid.

During Clock 6, the initiator latches the second data word and negates IRDYB to indicate to the

target that it is not ready for the next transfer. The target shall drive the third data word until the

initiator accepts it.

During Clock 7, the initiator asserts IRDYB to indicate to the target it is ready for the third data

word. It also negates FRAMEB since this shall be the last transfer.

During Clock 8, the initiator latches in the last word and negates IRDYB. The target, having seen

FRAMEB negated in the last clock cycle, negates TRDYB and DEVSELB. All of the above signals

shall be driven to their inactive state in this clock cycle, except for FRAMEB which shall be tri-

stated. The target shall stop driving the AD[31:0] bus and the initiator shall stop driving the

C/BEB[3:0] bus; this shall be the turnaround cycle for these signals.

PM7366-PI Datasheet(PDF) 264 Page - PMC-Sierra, Inc